Digitax M1 mdt User Manual

The information contained here are property of DIGITAX Automotive Electronics Italy, and extremely confi dential.
Any disclosure, copying, distribution to third
party is strictly prohibited.
31
Tariff Show
The procedure to use the Tariff Show is as follows:
1. Keep pressed K2 for few seconds to enter
in the menu selec on
2. Select TAR-SH by pressing K2
3. Confi rm by K4 the Tariff Show viewer
4. To go to the next programmed value press K4
5. To go to the previous programmed value press K3
Every  me K4 is pressed you will go to the next pa-
rameter index in the same order as specifi ed before
for each programmed block (up to 6).
When the last parameter index of the last block (t6)
is shown, by pressing K4 again the Tariff Show viewer
will display the Four Extras programmed values (from
F1 to F4):
To exit from Tariff Show menu and go back to For Hire
posi on, press OP.
...
TAR-SH
A T1 60.00
10.21
1200.00
B T1
60.00
A T1
90.0
B1 T1
4000.0
C T1
F1 T0 0.95
F2 T0 0.95
F3 T0 0.95
F4 T0 0.95
Initial AmountID TAR. NUMBER
Time 1st UnitID TAR. NUMBER
Initial AmountID TAR. NUMBER
Distance 1st UnitID TAR. NUMBER
Distance Other Units ID TAR. NUMBER
Extra AmountID TAR. NUMBER
Extra AmountID TAR. NUMBER
Extra AmountID TAR. NUMBER
Extra AmountID TAR. NUMBER

Digitax M1 mdt Specifications

General

Brand	Digitax
Model	M1 mdt
Category	Automobile Accessories
Language	English