EasyManua.ls Logo

Dilo SF6 - Transport and Installation; Transport Guidelines and Regulations

Dilo SF6
135 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Transport and installation
www.dilo-gmbh.com | 0300.bae
Transport:
To avoid damage to devices and life threatening injuries during transport:
Lifting slings must correspond to local health and safety regulations.
Slings should be chosen in accordance with the weight of the device.
(for weight see dimension sheet).
Version with lifting eyes:
Check that fork lift truck forks are long enough.
If the device is equipped with lifting eyes then a crane can be used. Ensure that
slings are of the correct length and chains do not cause damage to the device.
Do not stand underneath the load.
Only qualified and authorized persons should carry out transport operations.
Service carts with chassis may only be moved on even and solid ground. The
chassis is designed for a maximum speed of 6km/h.
Notes for transport of DILO devices with hydraulic weighing device
(not applicable for electronic weighing device)
The weight must be taken off the load cell prior to transport of the device.
(Danger of vibration/shock for the measuring system)
(see chapter 9 weighing device)
Transport regulations for DILO service carts
ADR regulations:
SF
6
(Sulphur hexafluoride) filled service carts are exempt from the ADR transport regulations if the
pressure of the gas in the vessel or tank is not exceeding 200 kPa (2 bar) at a temperature of 20°C and
the gas is neither liquid nor refrigerated liquefied gas.
This includes each kind of vessel or tank as well as machinery parts (see ADR 1.1.3.2 c exemptions with
regard to the transport of gases).
Otherwise please observe your country-specific transport regulations or guidelines.
Danger
Warning

Table of Contents

Related product manuals