DFW series indicators DFW_03_12.07_EN_U
38
until the instrument is turned off. In any case it is possible to make it so the code is cancelled as soon as it is printed
(UNLOCKED CODE).
- Press the keys “F” + “4” in sequence; the display indicates "MId n”.
- Press "1"; the display indicates "Id1 U" = CODE 1 UNLOCKED.
- Press the same keys again: the display indicates "Id1 L" = CODE 1 LOCKED.
- Repeat the same operations for CODE 2.
10.3 REPETITION OF THE LAST PRINTOUT MADE
Press in sequence the F and PRINT keys: the last printout made by the indicator will be repeated.
NOTES:
- By turning off the instrument, the information relative to the last printout made, will be lost; therefore this function is not
enabled until the first printout is made.
- This function is avalaible only in the DFW type indicators.
11. SELECTABLE OPERATING MODES
In addition to the STANDARD weighing mode - with TARE subtraction and transmission of data, the indicator can carry out
one of the following functions: UNIT OF MEASURE/POUNDS CONVERSION, NET/GROSS SWITCH, SET POINT ON
THE GROSS WEIGHT, SET POINT ON THE NET WEIGHT, IN/OUT, SINGLE - MULTISCALE REPEATER, ALIBI
MEMORY, +/- TOLERANCE CHECK, SAMPLE WEIGHT PERCENTAGE, SINGLE SCALE REPEATER, DISPLAY WITH
SENSITIVITY X 10, FREEZING OF THE WEIGHT ON THE DISPLAY, PEAK
DETECTOR, HORIZONTAL TOTALIZER,
VERTICAL TOTALIZER, PIECE COUNTING.
If using the DFWPM version, one should set the SINGLE – MULTISCALE REPEATER functioning mode.
Each functioning mode foresees the turning on of various function pilot lights, described in detail in the sections “KEYS
AND INDICATORS OF THE FRONT PANEL” and “SYMBOLS ON THE LCD DISPLAY”.
To set the operating mode, carry out the following procedures:
- Turn on the scale, press the TARE key while the firmware version is displayed (the display shows the “tyPE” menu).
- Press ZERO many times (to scroll ahead through the parameters) or TARE (to scroll backwards) until one finds the
“F.ModE” parameter.
- Press ENTER/PRINT to enter the menu (the display shows the “FunCt” menu).
- Press ENTER/PRINT to enter the parameter.
- With the ZERO or TARE keys select the possible options:
MAStr Single – multiscale repeater
rEPE Single scale repeater
NOTE: The above parameters are only displayed if the firmware (the instrument) is MASTER type
Std Unit of measure / pounds conversion
ntGS Net weight / gross weight conversion
StPG Set point on the GROSS weight
StPn Set point on the NET weight
inout Input / output weighing
ALibi Alibi memory
ChECk +/- Tolerance Check
PErC Sample weight percentage
ViSS Sensitivity times ten
hLd Hold
PEAk Peak detector
tot o Horizontal totalizer
tot S Vertical totalizer
Coun Counting
NOTE:The above parameters are only displayed if the firmware (the instrument) is STANDARD type.
To Next Page
Loading...
