DFW series indicators DFW_03_12.07_EN_U
41
- in.out input/output:
INPUT First weight with unit of measure.
OUTPUT Second weight with unit of measure.
NET Zero weight with unit of measure >> if WEIGH 1 = WEIGH 2
INPUT NET >> if WEIGH 1 > WEIGH 2
Difference without sign between INPUT and OUTPUT with unit of measure.
OUTPUT NET >> if WEIGH 1 < WEIGH 2
Difference without sign between INPUT and OUTPUT with unit of measure.
PROCEDURE:
- With the MODE key of the 5-key indicator (or keys “F”+ “1” of the 17-key indicator), one acquires the first weight, on the
display is shown “ - - 1 - - -“ accompanied by a prolonged beep;
- By pressing again the MODE key of the 5-key indicator (or keys “F”+ “2” of the 17-key indicator), one acquires the
second weight, and on the display is shown “- - 2 - - -“ accompanied by a prolonged beep.
- NOTE: The acquisition of the second weight is made only if the setting of the rEACt parameter in the set-up
environment has been respected (passage by zero of the weight, instability, or always); see the section
“REENABLING THE PRINTOUTS AND THE INDICATOR FUNCTIONS”.
- When the second weight is acquired, the data printout is commanded.
It is possible to interrupt the weighing cycle by pressing the ENTER/PRINT key (in the 5-key indicator) or C (in the 17-key
indicator) after the acquisition of the first weight: on the display the message “CLEAr?” is shown accompanied by a
prolonged beep. Press ENTER/PRINT to confirm the cancelling of the first acquired weight or another key to not confirm.
NOTES:
- The weight is acquired if:
- With a NON APPROVED scale one has a STABLE weight and GREATER than 0.
- With an APPROVED scale one has a STABLE weight and GREATER than 20 divisions.
- If the setting of the rEACt parameter in the set-up environment has been respected (passage by zero of the weight,
instability, or always); see the section “REENABLING THE PRINTOUTS AND THE INDICATOR
FUNCTIONS”.
- The tare operations are DISABLED.
To Next Page
Loading...
