Dini Argeo DFWL - Page 60

DFW series indicators DFW_03_12.07_EN_U
60
Er
–
85
It is displayed when the instrument has been initialized but not yet been calibrated.
Press the TARE key when the instrument displays “Er – 85” to enter the technical set-up environment and
carry out the calibration.
C.Er.
–
36
During the calibration some internal negative points have been calculated:
- the calibration point is less than the zero point.
-
the signal is negative (check the connections)
undEr
(blinking)
the weight in underload (i.e. a weight of 100 divisions below the gross zero
,
if the instrument is approved
)
i
s
notified through this message and by an acoustic signal.
oVEr
(blinking)
the weight in overload (i.e.
a
weight
of 9 divisions greater than the
capacity
)
is notified through this message
and by an acoustic signal.
ECo X
It is displayed for an instant if the master can connect to the slave X; if the connection is not possible, the
message remains fixed and the master emits an acoustic signal.