To Next Page
C
Corey SilvaSep 13, 2025
Why does my Directed Remote Starter say that speed was detected?
- RrileypatrickSep 13, 2025
The vehicle was detected as moving, which prevents the Directed Remote Starter system from shutting it down.
Why does my Directed Remote Starter say that speed was detected?
The vehicle was detected as moving, which prevents the Directed Remote Starter system from shutting it down.
What does DEI feature error mean on my Directed Remote Starter?
A feature config file mismatch was detected.
What to do if Directed 933.TL16 says CAN1 not detected?
If the Directed Automobile Accessories module reports that CAN1 is not detected, check the connections of the CAN1 Tan and Tan/Black wires. You can try to wake up the data bus by turning the ignition on and trying again. If your installation doesn't need this connection, you can skip this step by pressing the programming button 5 times.
What to do if Directed Automobile Accessories says CAN2 not detected?
If the Directed Automobile Accessories module reports that CAN2 is not detected, check the CAN2 Orange/Green and Orange/Brown wire connections. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
What to do if Directed Automobile Accessories says J1850 not detected?
Check the J1850 wire connection for your Directed Automobile Accessories. You might also need to wake up the data bus by turning the ignition on and trying again.
What to do if Directed 933.TL16 has bypass processing error?
Reset the Directed Automobile Accessories module and try again. If the condition persists, please contact Technical Support.
What to do if Directed Automobile Accessories says ISO 1 not detected?
Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections if the Yellow/Black wire of your Directed Automobile Accessories did not detect the expected signal.
What to do if Directed Automobile Accessories says ISO 2 not detected?
Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections if the Orange/Black wire of your Directed Automobile Accessories did not detect the expected signal.
What to do if Directed Automobile Accessories says MUX not detected?
Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections if the Violet/Green or Violet/Brown wire of your Directed Automobile Accessories did not detect the expected voltage value.
What to do if Directed 933.TL16 has DEI feature error?
Please contact Technical Support if you encounter a DEI feature error with your Directed Automobile Accessories.
General| Brand | Directed |
|---|---|
| Model | 933.TL16 |
| Category | Automobile Accessories |
| Language | English |
