What to do if CAN1 is not detected in Directed Remote Starter?
Verify the connections of the CAN1 Tan and Tan/Black wires. Then, wake up the data bus by turning the ignition on and try again. If your installation doesn't need this connection, skip this step by pressing the programming button 5 times.
What to do if J1850 is not detected on Directed Remote Starter?
Check the J1850 wire connection. Then, wake up the data bus by turning the ignition on and try again.
What to do if Directed Remote Starter shows a bypass processing error?
The bypass calculation has failed. Reset the module and try again.
What to do if Directed Remote Starter is waiting to begin the programming sequence?
Make sure that you are following the correct programming procedure.
Why is the CAN bus incorrectly detected in my Directed Remote Starter?
Verify the CAN1 and CAN2 connections.
How to fix Directed Remote Starter initialization failed?
Reset the module and complete the programming again.
Why Directed 933.TL16 says 'Runsafe was not disabled'?
No UNLOCK command was received prior to opening the door, or the 45 second timer expired in takeover mode.
What does 'PTS shutdown error' mean on my Directed 933.TL16?
The PTS output from the module was not activated due to safety protection.
Why Directed 933.TL16 Automobile Accessories says 'Brake was not detected'?
The brakes were not detected, which prevents the system from shutting down the vehicle.
Why Directed 933.TL16 says 'Smart key was not detected'?
The smart key was not detected, which prevents the system from shutting down the vehicle.
General| Brand | Directed |
|---|---|
| Model | 933.TL16 |
| Category | Automobile Accessories |
| Language | English |
To Next Page