To Next Page
V
Vanessa WyattSep 8, 2025
Why brake was not detected on Directed Control Unit?
- BBrandon WashingtonSep 8, 2025
The brakes were not detected, which prevents the system from shutting down the vehicle.
Why brake was not detected on Directed Control Unit?
The brakes were not detected, which prevents the system from shutting down the vehicle.
What to do if Directed 933.TL16 transponder functions were skipped?
If compatible and when RXT mode is not desired or convenience features are needed, reset and reprogram the module.
What to do if ISO 1 is not detected on Directed Automobile Electronics?
If the Yellow/Black wire did not detect the expected signal for the Directed Automobile Electronics, refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
What to do if my Directed Remote Starter shows CAN2 not detected?
If your Directed Remote Starter displays a 'CAN2 not detected' message, check the connections of the CAN2 Orange/Green and Orange/Brown wires. Wake up the data bus by turning the ignition on and try again. If the installation doesn't require this connection, skip this step by pressing the programming button 5 times.
What does it mean if OBDII feature is not supported in Directed Automobile Accessories?
If the OBDII feature is not supported in your Directed Automobile Accessories, the diagnostic data bus was not detected, therefore the SmartStart features will be limited.
What to do if Directed 933.TL16 CAN bus incorrectly detected?
Verify the CAN1 and CAN2 connections. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
What to do if MUX is not detected on Directed 933.TL16 Automobile Accessories?
The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Check the connections.
Why Directed 933.TL16 Automobile Accessories says 'OBDII feature not supported'?
The diagnostic data bus was not detected, therefore the SmartStart features will be limited.
What to do if there is a bypass processing error on Directed Control Unit?
Reset the module and try again. If the condition persists, please contact Technical Support.
What does it mean when my Directed 933.TL16 Automobile Accessories says 'MUX not detected'?
The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Check the connections.
General| Brand | Directed |
|---|---|
| Model | 933.TL16 |
| Category | Automobile Accessories |
| Language | English |
