Directed 933.TL16 - User Manual

23 pages

Save Page as PDF

To Next Page

DS3+ / DS4+

933.TL16

v1.03.198.9

2019 Toyota RAV4

Main Page

Questions and Answers

M
Melissa AndersonSep 15, 2025
What to do if Directed 933.TL16 has DEI feature error?
- M
  Mr. Ian MorrisSep 15, 2025
  Please contact Technical Support if you encounter a DEI feature error with your Directed Automobile Accessories.
D
doughertymaryAug 26, 2025
What to do if ISO 2 is not detected on Directed Automobile Electronics?
- D
  David OliverAug 26, 2025
  If the Orange/Black wire did not detect the expected signal for the Directed Automobile Electronics, refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
M
Michael RobbinsAug 26, 2025
What to do if ISO 1 is not detected on Directed Automobile Electronics?
- D
  Dawn KellerAug 26, 2025
  If the Yellow/Black wire did not detect the expected signal for the Directed Automobile Electronics, refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
K
kimberlypittsAug 30, 2025
How to troubleshoot Directed 933.TL16 module with no power?
- J
  James LeeAug 30, 2025
  First, check that the D2D harness is properly connected. Then, verify that there is 12 Volts present between the red and black wires. If the voltage is correct, the Directed module might be defective.
G
Greg BrennanAug 31, 2025
What to do if MUX is not detected on Directed 933.TL16 Automobile Accessories?
- L
  Lucas PerezAug 31, 2025
  The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Check the connections.
E
Elizabeth MartinezSep 1, 2025
Why speed was detected on Directed Automobile Accessories?
- J
  Jeffrey StuartSep 1, 2025
  The vehicle was detected as moving, which prevents the system from shutting it down.
A
allensusanSep 22, 2025
What to do if Directed Remote Starter is waiting to begin the programming sequence?
- D
  Darren HallSep 22, 2025
  Make sure that you are following the correct programming procedure.
M
Michelle WilliamsSep 6, 2025
What to do if there is a bypass processing error on Directed Control Unit?
- W
  williamsjamesSep 7, 2025
  Reset the module and try again. If the condition persists, please contact Technical Support.
R
rebeccashortSep 13, 2025
What does DEI feature error mean on my Directed Remote Starter?
- A
  Anthony ChandlerSep 13, 2025
  A feature config file mismatch was detected.
M
Mrs. Shannon JonesAug 25, 2025
What to do if Directed Automobile Electronics initialization failed?
- D
  Donna BanksAug 25, 2025
  If the Directed Automobile Electronics initialization failed, reset the module and complete the programming again. If the issue persists, please contact Technical Support.