What to do if ISO 1 is not detected on Directed Automobile Electronics?
If the Yellow/Black wire did not detect the expected signal for the Directed Automobile Electronics, refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
Why Directed 933.TL16 Automobile Accessories says 'OBDII feature not supported'?
The diagnostic data bus was not detected, therefore the SmartStart features will be limited.
Why Directed Automobile Accessories waiting to begin the programming sequence?
Ensure the correct programming procedure is being followed.
What to do if my Directed Remote Starter shows CAN2 not detected?
If your Directed Remote Starter displays a 'CAN2 not detected' message, check the connections of the CAN2 Orange/Green and Orange/Brown wires. Wake up the data bus by turning the ignition on and try again. If the installation doesn't require this connection, skip this step by pressing the programming button 5 times.
How to troubleshoot Directed Control Unit when module has no power?
Make sure the D2D harness is connected and that 12 Volt is present between the red and black wires. If 12 Volt is present, the module may be defective.
What causes a bypass processing error in Directed 933.TL16 Automobile Accessories?
Reset the module and try again. If the condition persists, please contact Technical Support.
What does PTS shutdown error mean on Directed Control Unit?
The PTS output from the module was not activated due to safety protection.
What to do if my Directed Remote Starter shows that ISO 2 is not detected?
The Orange/Black wire didn't detect the expected signal. Check the connections.
What to do if Directed 933.TL16 Automobile Accessories module has no power?
First, ensure the D2D harness is connected and that there's 12V present between the red and black wires. If 12V is present, the module might be defective.
What to do if CAN1 is not detected on Directed 933.TL16 Automobile Accessories?
Check the CAN1 Tan and Tan/Black wire connections. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
General| Brand | Directed |
|---|---|
| Model | 933.TL16 |
| Category | Automobile Accessories |
| Language | English |
To Next Page