Directed DS3+

17
933.HONDA9 2.10.198.12 2018 Honda Civic (Smart Key)
©2023 Directed. All rights
Module programming for convenience features only (skip transponder programming)
Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.
To connect the module:
1
Ensure vehicle is in a safe location and cannot move forward during programming. For vehicles
equipped with a manual transmission, make sure the gearshift is in the neutral position.
2
Connect the 12-pin main power harness to the module.
DS3+: Wait until the LED turns on solid red then proceed to the next step.
DS4+: The LED turns ON solid blue for 1 second to confirm Bluetooth communication. Wait until
the LED turns on solid red, then proceed to the next step.
4 2442
22 810 12
Must connect
12-pin FIRST
SolidSolid
DS3+ DS4+
Solid
1 Sec
OR
3
Connect remaining harnesses to the module then press the programming button five (x5) times.
The LED turns ON solid orange.
Connect
remaining
harnesses
4 2442
22 810 12
Solid
Press &
Release x5
4
Turn ignition ON and wait until the LED turns OFF.
START
Key IN
ON
OFF
Off
5
Turn ignition OFF.
START
Key OUT
ON
OFF
6
Pair remotes (if applicable).
Pair
remotes*
AFTERMARKET
* Your aftermarket remote may differ from the model shown in the illustrations. For information on how to pair a specific remote, please refer
to its corresponding owner documentation, which can be found inside the product packaging of the complete system or on www.directechs.
com.
You have successfully completed the module programming sequence.