Dish Network 40.0 - Linking Remote to Receiver; Verify Receiver Antenna Setup; Initiate and Test Remote Linking

4
Linking Remote to Receiver
Verify the antenna
is installed on the back
of the receiver.
Turn your receiver and
TV on, and press
SYSTEM INFO on the
front panel of the receiver.
Conrm that you
see the System
Info screen.
Press and release SAT
on your remote. Wait until
you hear a tone and see
the remote listed on the
screen.
Conrm that your remote
operates your receiver by
pressing remote buttons.
If this is not working, go
back to step 4.
3
2
1
4
5
Use these instructions
to link the remote
to the receiver if
your receiver does
not support System
Wizard.
R
E
M
OT
E
A
N
T
E
N
NA
SYSTEM
INFO