Dixie Narco P Series - Page 22

PROGRAMMING P-SERIES
Page 22 of 78
LT – Lighting available only when Environmental Controls are set to on.
This function is used to turn the lights off during certain periods of the day. To enter the sub-menu press
select button 1. The following are sub-menus of the Light Menu: “Days”, (STRT) “Start”, “Stop”, (ENAB)
“Enable”, and (RTN) “Return”. To move to Refrigeration, press & hold select buttons 1 & 2
simultaneously.
Pressing select button 1 will enter “Days”.
Days
This function is used to set the days of the week to turn lights off.
Day of the week:
(SUN) Sunday (WED) Wednesday (SAT) Saturday (RTN) Return (RTN)
(MON) Monday (THUR) Thursday (ALL) All Days
(TUE) Tuesday (FRI) Friday (NONE) No Days
Press select button 1 and "MON#” will show on the display, where # is “0” (disable) or “1”
(enable). Press and hold select button 1 to toggle between “0” and “1”. Release the select button
with the display showing the setting you wish to use. Press select buttons 1 & 2 simultaneously
to scroll through all available days, “ALL”, “NONE”, and “RTN”. Press select button 1 at the
“RTN” prompt returns to “Days”.
Press & hold select buttons 1 & 2 simultaneously to move to the next item on the menu.
STRT - Start
This function is used to set the hours and minutes to start lighting routine.
Press select button 1 and the current four-digit hour and minute setting will be displayed.
(24 hour).
Press & hold select button 1: Set Hours
Press & hold select button 2: Set Minutes
Press select buttons 1 & 2 simultaneously to move to the next item on the menu.
Stop
This function is used to set the hours and minutes to stop lighting routine.
Press select button 1 and the current four-digit hour and minute setting will be displayed.
(24 hour)
Press & hold select button 1: Set Hours
Press & hold select button 2: Set Minutes
Press select buttons 1 & 2 simultaneously to move to the next item on the menu.
ENAB - Enable
This function is used to allow the lighting routine to go in to affect.
Press select button 1 and the current setting will be displayed (On or Off).
Press and hold select button 1 to toggle between “On” and “Off”.
Release the select button showing the setting you wish to use and display will return to “Enable”.
Press select buttons 1 & 2 to scroll to “Return”.
RTN - Return
Press select button 1 to return to “Light”.
Press & hold select buttons 1 & 2 simultaneously to move to the next item on the menu.