dji FLYCART 30 - Page 11

DJI FlyCart 30 User Manual
©
2024 DJI All Rights Reserved.
11
Detection Range
Binocular vision system: 90° (horizontal), 180° (vertical), 0.5-29 m.
Forward phased array radar: 360° (horizontal), ±45° (vertical), ±45° (upward, cone), 1.5-50 m.
Rear phased array radar: 360° (vertical), ±45° (horizontal), 1.5-200 m.
• The aircraft cannot sense obstacles that are not within the detection range. Fly with caution.
• The effective detection range varies depending on the size and material of the
obstacle. When sensing objects such as buildings that have a radar cross section (RCS)
of more than -5 dBsm, the effective detection range is 50 m. When sensing objects
such as power lines that have an RCS of -10 dBsm, the effective detection range is
approximately 30 m. When sensing objects such as dry tree branches that have an RCS
of -15 dBsm, the eective detection range is approximately 20 m. Obstacle sensing may
be aected or unavailable in areas outside of the eective detection distance.
• Fly with caution when the aircraft is near an obstacle that is at a similar altitude as the
bottom of the aircraft. The aircraft will not be able to detect the obstacle as most or even
the whole obstacle is out of the detection range.
Horizontal Obstacle Avoidance Function
Enable the function in DJI Pilot 2.
Obstacle avoidance is used in the following two scenarios:
1. The aircraft begins to decelerate and hovers in place when it detects an obstacle and the
distance is less than the safety distance that corresponds to the current ight speed. While
decelerating, users cannot control the aircraft. The aircraft enters obstacle avoidance mode
after hovering in place. Users can fly in a direction away from the obstacle to regain full
control of the aircraft.
2. The aircraft begins to decelerate and hovers in place when it detects an obstacle and the
distance is further than the safety distance that corresponds to the current flight speed.
While decelerating, the user cannot accelerate in the direction of the obstacle, but can y in
a direction away from the obstacle.
• Obstacle avoidance is disabled during auto landing. Make sure to operate the aircraft with
caution when controlling the aircraft manually during auto landing.
• In some scenarios, such as with power lines, small obstacles, or objects that are at the
same level as the landing gear, obstacle sensing may be rendered ineffective. Fly with
caution.
Vertical Obstacle Avoidance Function
Enable the function in DJI Pilot 2. The aircraft begins to decelerate and hovers in place when
it detects an obstacle via vertical obstacle sensing. When the aircraft is braking or hovering,
users cannot accelerate in the direction of the obstacle, but can y in a direction away from the
obstacle.
• Downward obstacle sensing is unavailable when using the winch system.