dji SPARK User Manual

26
©
2017 DJI All Rights Reserved.
Spark
User Manual
Flight Recorder
Flight data is automatically recorded to the internal storage of the aircraft. This includes ight telemetry,
aircraft status information, and other parameters. To access this data, connect the aircraft to the PC
through the Micro USB port.
Attaching and Detaching the Propellers
Only use DJI approved propellers with your Spark. White ringed and unmarked propellers indicate where
they should be attached and in which direction whey should spin.
Marked Unmarked
Detaching the Propellers
Press the propellers down into the motor mount and rotate them in the unlock direction.
Propeller blades are sharp; please handle with care.
Only use DJI approved propellers. Do not mix propeller types.
Stay clear of spinning motors. Do not touch the propellers when they are spinning.
Ensure to check that the propellers and motors are installed rmly and correctly before each
ight.
Ensure that all propellers are in good condition before each ight. Do not use aged, chipped,
or broken propellers.
To avoid injury, stand clear of and do not touch propellers or motors when they are spinning.
Please use original DJI propellers for a better and safer ight experience.
Propellers White Ring Unmarked
Figure
Attach On Motors with white marks Motors without white marks
Legend Lock : Turn the propellers in the indicated direction to mount and tighten.
Attaching the Propellers
Attach the propellers with the white rings to the mounting base with white marks. Press each propeller
down onto the mounting plate and rotate in the lock direction until it is secured. Attach unmarked
propellers to the mounting bases without marks. Unfold all the propeller blades.

dji SPARK Specifications

Operating Environment

max speed	31 mph (50 kph)
operating temperature	32° to 104° F (0° to 40° C)
charging temperature	41° to 104° F (5° to 40° C)

Camera

sensor	1/2.3” CMOS
effective pixels	12 Megapixels
video recording modes	FHD: 1920×1080 30p

Power

charger input	100-240 V, 50/60 Hz, 0.5 A
charger output	5 V 3 A / 9 V 2A / 12 V 1.5 A
battery capacity	1480 mAh

Remote Control

operating frequency	2.4G / 5.8G
max transmission distance (Wi-Fi)	100 m (Distance), 50 m (Height)
max transmission distance (Remote Controller)	2000 m

Weight and Dimensions

weight	300 g
dimensions	143×143×55 mm