Zenmuse Z15-A7
User Manual
©
2015 DJI. All Rights Reserved.
15
details.
3. Setup the Aileron, Elevator, and Rudder channels on the gimbal control TX. The command stick will control
gimbal rotation velocity. The center position is 0, and the end point is maximum velocity in both clockwise
and counter clockwise directions. (The end point is 100%)
4. Choose one 3-position switch/channel to use as the Z15-A7 Working Mode switch. (MODE)
5. Choose one 2-position switch/channel to use as the camera shutter control switch (SHUT), and another
2-position switch to use as the camera lens orientation switch in Reset Mode (AUX2).
6. Choose one 2-position switch/channel to use as the camera video recording control switch (AUX3).
7. Please refer to the Wookong-M User Manual for aircraft control settings.
8. Connect the receiver to the GCU correctly.
GCU Ports
The following table shows the connections between the GCU channels and the relevant TX channels.
TX Channels
GCU Chan-
nels
Indications
JR Futaba/Hitec
AILE 1 ROLL For roll axis control (left/right). Velocity is zero if disconnected.
ELEV 2 TILT For tilt axis control. Velocity is zero if disconnected.
RUDD 4 PAN For pan axis control. Velocity is zero if disconnected.
AUX2 7 MODE For Working Mode switch.
2-position switch channel SHUT For camera shutter control.
2-position switch channel AUX1 Reserved channel.
Or Futaba S-Bus channel AUX2
When AUX2 is connected to a 2-position switch channel, it
is used as a camera orientation (down or forward) switch
in FPV Mode (Reset). The camera orientation is forward if
disconnected.
Or if you are using a S-Bus receiver, connect the recever to
the AUX2 port.
2-position switch channel AUX3 For camera video recording control.
The following table shows the corresponding relationship between the GCU and the S-Bus channels.
S-Bus Channels GCU Channels S-Bus Channels GCU Channels
1 ROLL 5 SHUT
2 TILT 8 AUX1
4 PAN 9 AUX2
7 MODE 6 AUX3
GCU Wiring
To Next Page
Loading...
