dji Zenmuse Z15-A7 - Shutter Control; Video Recording Control

©
2015 DJI. All Rights Reserved.
17
If the shutter control does not work correctly, please check each step.
The following diagram shows how the shutter control works.
2-Positon
Switch
3-Positon
Switch
3-Positon
Switch
Shutter Control
The Z15-A7 gimbal can transform a TX command into a shutter control signal. Select a 2-position switch/
channel to use for remote shutter control.
For whichever 2-position switch you select, connect the correct receiver channel to the SHUT port. Toggling
the 2-position switch works as follows:
Position-1 Position-2: Take one photo
Position-2 Position-1: Reset switch position (no shutter effect or action)
Position-1 Position-2: Take another photo
Video Recording Control
The Z15-A7 supports starting and stopping your camera’s video record function by using a 2-position switch
through AUX3. Connect the relevant channel of the receiver to the AUX3 port. Toggle the switch to start/stop
recording.
Position-1: Start recording
Position-2: Stop recording
If the video recording control does not work correctly, please check each step.
The following diagram shows how the shutter control works.
2-Positon
Switch
3-Positon
Switch
3-Positon
Switch
TX
2-Position Switch
TX Command TX Command TX Command
Wireless
RC Receiver
3-Pin Cable
Internal Cable
HDMI-HD/AV
Module
Gimbal
Camera
GCU
Shutter Button
2-Position
Switch Channel
SHUT
Infrared Remote Control
Working Mode/AUX2 Switch Setup / Video Recording Control