dji Zenmuse Z15-A7 - Specifications

Zenmuse Z15-A7
User Manual
26
©
2015 DJI. All Rights Reserved.
Specications
General
Built-In Functions Three Working Modes
Orientation-locked control
Non orientation-locked control
FPV mode (Reset)
Built-in independent IMU module

DJI gimbal special servos drive module
HDMI-HD/AV module
Infrared remote control module
Wireless video transmission
supported
Camera shutter/video recording
control supported
Wide range voltage input supported
S-Bus Receiver supported
Peripheral
Supported Camera Sony ILCE-7S; Sony ILCE-7R
Supported Lens Sony FE 35 mm f2.8 ZA
GCU Input Power 4S~12S LiPo (Recommend 6S if with S1000+)
Control Requirement At least four spare receiver channels
Assistant Software System
Requirements
Windows XP SP3; Windows 7; Windows 8 (32 or 64 bit)
Mechanical & Electrical Characteristics
Working Current Static current: 200mA (@25V)
Dynamic current: 400mA (@25V)
Locked-motor current: 4A (@25V)
Operating Temperature -10 °C ~ 50 °C
Weight 1.3 Kg
Dimensions 210 mm × 204 mm × 246 mm
GCU Weight 63 g
GCU Dimensions 64.2 mm × 34.1 mm × 19.5 mm
Working Performance
Load Weight (Reference Value) 622 g(@Sony ILCE-7S with Sony FE 35 mm f2.8 ZA, battery, lens hood and
SD Card) ; 580 g(@Sony ILCE-7R with Sony FE 35 mm f2.8 ZA, battery,
lens hood and SD Card)
Angular Vibration Range ±0.01°
Maximum Controlled
Rotation Speed*
Pan axis: ±130°/s
Tilt axis: ±130°/s
Roll axis: ±30°/s
Controlled Rotation Range Pan axis control: ±360° continuous rotation
Tilt axis control: +50°/-140°
Roll axis control: ±40°
Note*: Gimbal’s Maximum Controlled Rotation Speed corresponds to TX stick input pushed to 100% end-points.
Appendix