dji Zenmuse Z15-A7 - Appendix; Attention; 1 Pilot Solution

22
©
2015 DJI. All Rights Reserved.
Appendix
Attention
For safety reasons, please pay careful attention to all of the following items:
1. To avoid motor damage, ensure nothing blocks the servo drive module’s total range of movement.
2. Before powering on, spin the gimbal through its complete rotation by hand on each axis to ensure nothing
is blocking the mechanical movement of the gimbal.
3. Be sure to mount the side of servo drive module 1 with the ports facing towards the aircraft's tail.
4. The gimbal’s center of gravity has been preset. The gimbal balance is directly related to its performance.
Follow the instructions in this manual to adjust the center of gravity if you are using the Sony ILCE 7R
camera, otherwise do not adjust the gimbal’s center of gravity.
5. The gimbal is a sophisticated device. Do not remove any screws from the gimbal. Doing so may result in
poor performance or damage.
6. Do not unplug any cables attached to the gimbal ports or change the mechanical structure.
7. Make sure all wiring is correct, otherwise the gimbal may not operate correctly or efciently.
8. Make sure to connect the wireless video transmission module to the GCU prior to powering on the system.
9. We recommend use of the included AV video power cable, if needed.
10. Be sure to solder the AV video power cable to the wireless video transmission module correctly. Ensure
the cables are insulated and protected to prevent any type of short circuit.
11. Pay close attention to the voltage of S1000+ and be sure it is within the dened limits (6S) when using
one battery for both the S1000+ and as a power supply for the gimbal.
12. Never touch the contact points of a power cable to the gimbal, this may lead to a short circuit of the
gimbal, resulting in complete failure.
13. Before powering on, adjust the roll axis of the gimbal to be level.
1-Pilot Solution
14V
52V
Flight Controller（DJI WooKong-M）
GCUGCU
ROLL
TILT
PAN
MODE
SHUT
AUX1
AUX2
AUX3
Gimbal Control Unit（GCU）
3-Position Switch
3-Position Switch
3-Position Switch
3-Position Switch
2-Position Switch
2-Position Switch
2-Position Switch
3-Position Switch
14 Channels Receiver(Futaba)
Gimbal Control
Flight Control
Transmitter
A7
HD
-
Appendix