dji Zenmuse Z15-A7 - Page 9

Zenmuse Z15-A7
User Manual
©
2015 DJI. All Rights Reserved.
9
2. Mount the camera onto the gimbal as shown and tighten the lens retaining ring. Then tighten the camera
mounting screw.
3. Rotate the camera to any tilt angle, if it stays in position, then proper balance has been achieved.
Otherwise adjust the camera’s position by sliding the positioning board until the proper balance is
achieved.
4. Loosen the eight screws on the connection point of the pan axis. Then slide the pan axis forward about
0.5mm and tighten the screws. When the proper balance is achieved, the pan axis will stay in position after
rotating the gimbal 90 degrees. Balancing is complete.
Slide the pan axis forward about 0.5mm
Mount