DMP 8860 - Program Z-Wave Devices; Z-Wave Lights; Z-Wave Doors; Z-Wave Thermostat

To Next Page

To Previous Page

8860 Installation and Programming Guide | Digital Monitoring Products 12

Program Z-Wave Devices

The Z-Wave menu allows the user to operate their Z-Wave home automation devices at the keypad. Press Z-Wave

categories such as Lights, Doors, Thermostats, Appliances, and Favorites in the Carousel menu to conﬁgure their

settings.

In the Carousel menu, press Favorites or select a Z-Wave device. Then, tap the Settings icon in the bottom right corner

to conﬁgure device settings.

Note: Z-Wave Lights, Doors, Thermostats, Appliances, and Favorites needs to be enabled in the Carousel Shortcut

Items list to conﬁgure Z-Wave settings.

Z-Wave Lights

Z-Wave lights can be turned on and o at the keypad. Use the multilevel slider on the

right side of the light to set the light at 0, 25, 50, 75, or 100. 0 is O and 100 is On. To

reset the metered switch for a light, press RESET underneath the light you want to reset.

Z-Wave Doors

Z-Wave doors can be locked or unlocked at the keypad. The keypad will show the lock

battery level next to the door the lock is assigned to. The garage door icon animates as

it is opening or closing. Press Open or Close to activate the garage door animation.

Z-Wave Thermostat

Z-Wave thermostats can be controlled at the keypad. Use the slider handles or the

setpoint increase and decrease buttons to change the temperature. When there are

multiple Z-Wave thermostats on a system, swipe the screen to the left to access

additional thermostats.

Z-Wave Appliances

Z-Wave appliances can be turned on or o at the keypad. Use the multilevel slider on

the right side of the light to set the light at 0, 25, 50, 75, or 100. 0 is O and 100 is On.

Z-Wave Favorites

Z-Wave favorites can be assigned at the keypad. Press Activate next to the name of the

favorite that you want to activate. The name of the favorite will change to Activated

after the process is complete.