14
Basic Instructions Screen (1 of 2) After Pushing F1 Twice.
• Pressing F1 a third time or using the left or right
arrow keys will show the DISPLAY INSTRUCTIONS
screen.
Display Instructions Screen (2 of 2) After Pushing F1 Three (3) Times.
2. VIEW (F2). Pressing F2 will display the VIEW screen.
This screen is set up with messages to prompt the
operator on the actions needed to quickly operate
the machine in automatic. This screen shows the
operator what mode the machine is in and the details
of the job that is currently selected. Also displayed
is the vise mode, the position of the index vise, the
set-point and the actual position. On the right side
of the display is band speed set point and actual
band speed time required for the last cut is displayed
which is updated at the end of each cut.
4. Most screens have instructions on the screen to
assist in entering information.
Do not push two (2) or more buttons at the
same time.
Screens
1. SCREENS (F1). When both the variable frequency
drive disconnect and the control enclosure
disconnects are "ON", push Hydraulic Start. The
display will light up and show the initial screen below.
Note the list of what the various function keys do. If
the saw has been in use and you wish to display this
screen push F1. Use the left and right arrow keys
as needed to move between various screens.
Initial Screen Display (F1).
• Pressing F1 again or using the right and left arrow
keys will show the BASIC INSTRUCTIONS Screen
to assist the operator in initial saw operation.
Function Keys -- Lower Left Operator Work Station.
OPERATOR WORKSTATION (Continued....)
To Next Page
Loading...
