DoAll C-4100NC - Machine Alignment; Wear Plate Replacement; Vise Jaw Plates; Front Vise Guide Rails

32
LUBRICATION CHART
LUBRICATION
LOCATION DESCRIPTION AND
SERVICE RECOMMENDATIONS
RECOMMENDED
LUBRICANT
LUBRICATION
INTERVAL*
LUBRICATION
POINT NO.
High quality, rust and oxidation-inhibited,
medium hydraulic and general purpose
industrial oil.
ISO-VG Grade 68 (Formerly ASTM Grade
No. 315).
Union 76, UNAX RX 68, or equivalent.
Premium quality, multi-purpose lithium-
base, EP (extreme pressure) grease.
NLGI No. 2.
Union 76, UNOBA EP 2, or equivalent.
Saw Guide Arm Slide. Clean and apply oil.
1
MONTHLY
Micellaneous: Vise Slide, Hinges, Pivot Points,
Component Parts, Unpainted Surfaces, etc. To ensure
function and maintain appearance while reducing wear,
corrosion, rust, etc. Apply when and where needed in
amounts required.
6
MONTHLY
2
7
4
Index Vise Movable Jaw Ways. Four (4) grease ttings.
Saw Guide Adjustment Screws. Clean and apply oil.
Idler Bandwheel Slide. Two (2) grease ttings.
MONTHLY
6 MONTHS
Electric Motors. Oil cup and/or grease ttings.
Lubricate (if any) per manufacturer's recommendations.
10
Premium quality, saw band coolant and
lubricant.
DoALL cutting uids and/or oils.
Coolant Reservoir. 20 gallon (75.7 liter) capacity. Drain,
clean and rell whenever coolant becomes undesireable for
further use. Clean the mesh screen at the same time.
9
AS REQUIRED
* Lubrication intervals are based on a 8-hour day, 40-hour week.
Lubricate more often with heavier use.
Hydraulic System. Ten (10) gallon (37.8 liter) capacity.
Check uid level daily and keep the reservoir full. Drain,
change the lter element and rell after the 1st month;
every six (6) months thereafter.
CHECK DAILY/
AS REQUIRED
8
INSERT CHANGE
MONTHLY
Idler Bandwheel Bearing. One (1) grease tting.
12
5
Sensing Arm. Clean and apply oil.
6 MONTHS
Transmission. 18 quart (17.0 liter) capacity. Drain and rell
every six (6) months. Donotoverll.
High quality, 4EP (extreme pressure) multi-
purpose gear oil.
Mobil Gear (629-YC1F4), Union Extra duty
NL Gear Lube.
S.A.E Grade No. 90.
11
MONTHLY
3
Index Vise Bearing Rails (5' Index Option). Four (4)
grease ttings.
CHECK DAILY/
AS REQUIRED
Band Mist Lubricator (Optional). Keep reservoir lled
and hoses clear.
Contact your DoALL sales representative
for the best oils and/or uids for your
application.
DoALL cutting uids and/or oils (AL-2000).
CHECK DAILY/
AS REQUIRED
Multi-purpose automatic transmission
uid.
General Motors Dexron III, or equivalent.
13