i
OPERATOR'S INSTRUCTION MANUAL
METAL CUTTING BAND SAW
PB-482.5 (7-13)
PRINTED IN U.S.A.
The following registered trademarks of the DoALL Company are used in this manual:
DoALL, Imperial Bi-Metal, Kleen-Kool, Polypac, Power-Cut and Tensigage.
MODEL FIRST SERIAL NO. LAST SERIAL NO.
C-4100NC 524-97116 524-11322
524-13338
For your information and future reference, pertinent data concerning your
machine should be written in the spaces provided above. This information is
stamped on a plate attached to your machine. Be sure to provide machine
model and serial numbers with any correspondence or parts orders.
Specications contained herein were in effect at the time this manual was
approved for printing. The DoALL Company, whose policy is one of continuous
improvement, reserves the right, however, to change specications or design
at any time without notice and without incurring obligations.
DoALL SAWING PRODUCTS
2375B TOUHY AVENUE
ELK GROVE, ILLINOIS 60007 U.S.A.
PLEASE READ THIS MANUAL CAREFULLY BEFORE OPERATING THE MACHINE!
For Sales, Parts and Service, call 1-888-362-5572
For general information, visit our web site at: www.doallsawing.com
To Next Page
Loading...
