DOD Technologies ChemLogic 1 - Page 43

43
DC-ITD-CL1andCL2MAN01-2018.A www.dodtec.com
NOV 2018 815-788-5200
CL1 & CL2 Manual
10
Flow Fluctuation
Fault
Flow Blocked and/or
Unstable Inlet/Exhaust
When blockage is fixed, go to Setup Menu and
enable pumps. If problem persists, contact
DOD (815) 788-5200.
11
Idle Timeout
Out of Analysis Beyond
Timer
Re-enter Analysis
12
Low Background
Fault
Wrong tape or optic
problem
Re-adjust optics - make sure fresh tape is
inserted and gate is closed. Then go to service
menu-Optic Calib and press start. If these
steps do not work, contact DOD DOD
Technologies Support @ (815)788-5200
13
Purge Option Fault
Tubing Blocked
Find block in sample line
14
Optic Auto Cal
Failure
Optics Dirty
See manual appendix H for cleaning
instructions and add a filter to inlet if possible.
Also, re-adjust optics - make sure fresh tape
is inserted and gate is closed. Then go to
service menu-Optic Calib and press start.
33
SD Card Fault
No SD Card or Card Full
If a SD card is installed remove and re-insert
34
Analyzing
Analysis mode started
N/A
35
ChemLogic Tape
Low
ChemLogic tape nearing
end
Replace tape
36
Pump 1 Disabled
Flow Blocked and/or
Unstable Inlet/Exhaust
Go to Setup Menu and enable pump. If
problem persists, contact DOD (815) 788-
5200.
37
Pump 2 Disabled
Flow Blocked and/or
Unstable Inlet/Exhaust
Go to Setup Menu and enable pump. If
problem persists, contact DOD (815) 788-
5200.
38
Large Flow
Fluctuation
Flow Blocked and/or
Unstable Inlet/Exhaust
When blockage is fixed, go to Setup Menu and
enable pumps. If problem persists, contact
DOD (815) 788-5200.
39
High Flow Fault
Optics Orifice Dirty
See manual appendix H for cleaning
instructions and add a filter to inlet if possible.
If problem persists, contact DOD (815) 788-
5200.
40
Alarm Level 1
Gas Detected
After gas leak is found and corrected, reset
alarms
41
Alarm Level 2
Gas Detected
After gas leak is found and corrected, reset
alarms
42
Remote Reset
N/A
43
Power On
N/A
44
Optic Calibration
Operator initiated
N/A
45
Pump 1 high voltage
Pump drawing high
current or Bad Pump
Leak somewhere between the optics and
pumps. Check that pumps are connected and
all fittings between the optics and the pumps
are fully inserted. If problem persists, contact
DOD (815) 788-5200.
46
Pump 2 high voltage
Pump drawing high
current or Bad Pump
Leak somewhere between the optics and
pumps. Check that pumps are connected and
all fittings between the optics and the pumps
are fully inserted. If problem persists, contact
DOD (815) 788-5200.