Dodge Durango 2018 - To Resume; Deactivation; Setting the Following Distance

Metric Speed (km/h)
• Pushing the SET (-) button once will result in
a 1 km/h decrease in set speed. Each subse-
quent tap of the button results in a decrease of
1 km/h.
• If the button is continually pushed, the set
speed will continue to decrease in 10 km/h
decrements until the button is released. The
decrease in set speed is reflected in the in-
strument cluster display.
To Resume
If there is a set speed in memory push the RES
(resume) button and then remove your foot from
the accelerator pedal. The instrument cluster
display will show the last set speed.
NOTE:
• If your vehicle stays at standstill for longer
than two seconds, then the system will cancel
and the brake force will be ramped-out. The
driver will have to apply the brakes to keep the
vehicle at a standstill.
• ACC cannot be resumed if there is a stationary
vehicle in-front of your vehicle in close
proximity.
WARNING!
The Resume function should only be used if
traffic and road conditions permit. Resuming
a set speed that is too high or too low for
prevailing traffic and road conditions could
cause the vehicle to accelerate or decelerate
too sharply for safe operation. Failure to fol-
low these warnings can result in a collision
and death or serious personal injury.
Deactivation
Push and release the Adaptive Cruise Control
(ACC) on/off button a second time to turn the
system off.
“Adaptive Cruise Control (ACC) Off” will appear
in the instrument cluster display to indicate the
ACC is off.
WARNING!
Leaving the ACC system on when not in use is
dangerous. Y ou could accidentally set the
system or cause it to go faster than you want.
You could lose control and have an accident.
WARNING!
Always leave the system OFF when you are
not using it.
Setting The Following Distance
The specified following distance for ACC can be
set by varying the distance setting between four
bars (longest), three bars (long), two bars (me-
dium) and one bar (short). Using this distance
setting and the vehicle speed, ACC calculates
and sets the distance to the vehicle ahead. This
distance setting appears in the instrument clus-
ter display.
• To increase the distance setting, push the
Distance Setting—Increase button and re-
lease. Each time the button is pushed, the
distance setting increases by one bar (longer).
•
To decrease the distance setting, push the Dis-
tance Setting—Decrease button and release.
Each time the button is pushed, the distance
setting decreases by one bar (shorter).
159