Fog Lights — If Equipped
The fog lights are turned on by rotating the head-
light switch to the parking light or headlight posi-
tion and pushing in the headlight rotary control.
The fog lights will operate only when the parking
lights are on or when the vehicle headlights are
on low beam. An indicator light located in the
instrument cluster display will illuminate when
the fog lights are on. The fog lights will turn off
when the switch is pushed a second time, when
the headlight switch is rotated to the off posi-
tion, or the high beam is selected.
Turn Signals
Move the multifunction lever up or down and
the arrows on each side of the instrument clus-
ter will flash to show proper operation of the
front and rear turn signal lights.
NOTE:
If either light remains on and does not flash, or
there is a very fast flash rate, check for a defec-
tive outside light bulb. If an indicator fails to
light when the lever is moved, it would suggest
that the indicator bulb is defective.
When the Daytime Running Lights are on and a
turn signal is activated, the Daytime Running
Lamp will turn off on the side of the vehicle in
which the turn signal is flashing. The Daytime
Running Lamp will turn back on when the turn
signal is turned off.
Lane Change Assist — If Equipped
Tap the lever up or down once, without moving
beyond the detent, and the turn signal (right or
left) will flash three times then automatically
turn off.
WINDSHIELD WIPERS AND
WASHERS
The windshield wiper/washer controls are lo-
cated on the multifunction lever on the left side
of the steering column. The front wipers are
operated by rotating a switch, located on the
end of the lever . For information on the rear
wiper/washer, refer to “Rear Window Wiper/
W asher” in this section.
Windshield Wiper Operation
Rotate the end of the lever to one of the first four
detent positions for intermittent settings, the
fifth detent for low wiper operation and the sixth
detent for high wiper operation.
Multifunction Lever
GETTING TO KNOW YOUR VEHICLE
38
To Next Page
Loading...
