Spare Tire Removal
1. Remove the jack tools from the bag.
2. Raise the rubber mat and remove the plug
from storage compartment floor .
3. Fit the jack handle extension over the drive
nut. Use the lug wrench handle and exten-
sion to completely lower the spare tire. Keep
turning the handle until the winch stops.
4. Slide the tire out from under the vehicle and
rotate it vertically behind the rear bumper .
5. Pull the metal stamping toward you to re-
lease it from the plastic plate.
6. Slide the metal stamping up the steel exten-
sion tube and winch cable. Rotate the metal
stamping and push it through the hole in the
plastic plate and wheel.
Winch Drive Nut Location
Spare Tire Removal
Spare Tire Retainer
IN CASE OF EMERGENCY
186
To Next Page
Loading...
