7. Pinch the three short and two long tubes to
remove the protective plate from the steel
spare wheel.
Preparations For Jacking
1. Park the vehicle on a firm, level surface as
far from the edge of the roadway as possible.
Avoid icy or slippery areas.
WARNING!
Do not attempt to change a tire on the side of
the vehicle close to moving traffic, pull far
enough off the road to avoid being hit when
operating the jack or changing the wheel.
2. Turn on the Hazard W arning flashers.
3. Apply the parking brake.
4. Place the gear selector into PARK.
5. Turn OFF the ignition.
6. Block both the front and rear of the wheel
diagonally opposite the jacking position. For
example, if the right front wheel is being
changed, block the left rear wheel.
NOTE:
Passengers should not remain in the vehicle
when the vehicle is being jacked.
Retainer Removal
Protective Plate Removal
Wheel Blocked
187
To Next Page
Loading...
