NOTE:
In case the ignition switch does not change with
the push of a button, the key fob may have a low
or dead battery. In this situation, a back up
method can be used to operate the ignition
switch. Put the nose side of the key fob (side
opposite of the Emergency Key) against the
ENGINE ST AR T/STOP button and push to op-
erate the ignition switch.
Dead Key Fob Battery
Key Not Detected Feature
If the ignition position does not change with a
push of the ignition button, and the instrument
cluster display message “Key Fob Not De-
tected” is being displayed, the key fob may have
a low or dead battery . In this situation, a back up
method can be used to operate the keyless push
button ignition. Put the nose side (side opposite
of the emergency key) of the key fob against the
keyless ignition push button and push to oper -
ate the ignition. Once the starter engages and
the engine starts remove the key fob from the
keyless ignition push button.
REMOTE START — IF EQUIPPED
To Enter Remote Start Mode
Push and release the remote start button on the
key fob twice within five seconds. The vehicle
doors will lock, the parking lights will flash, and
the horn will chirp twice (if programmed). Then,
the engine will start, and the vehicle will remain
in the Remote Start mode for a 15-minute cycle.
NOTE:
• If an engine fault is present or fuel level is low,
the vehicle will start and then shut down in
10 seconds.
• The park lamps will turn on and remain on
during Remote Start mode.
• For security , power window and power sunroof
operation (if equipped) are disabled when the
vehicle is in the Remote Start mode.
• The engine can be started two consecutive
times with the key fob. However , the ignition
must be cycled by pushing the ST AR T/STOP
button twice (or the ignition switch must be
cycled to the ON/RUN position) before you
can repeat the start sequence for a third cycle.
To Exit Remote Start Mode Without Driving
The Vehicle
Push and release the remote start button one
time or allow the engine to run for the entire
15-minute cycle.
NOTE:
To avoid unintentional shutdowns, the system
will disable with a one time push of the remote
start button for two seconds after receiving a
valid remote start request.
Low Or Dead Key Fob Battery Starting
Procedure
GETTING TO KNOW YOUR VEHICLE
16
To Next Page
Loading...
