CAUTION!
The Sentry Key Immobilizer system is not
compatible with some aftermarket remote
starting systems. Use of these systems may
result in vehicle starting problems and loss of
security protection.
All of the key fobs provided with your new vehicle
have been programmed to the vehicle electronics.
Customer Key Programming
Programming key fobs may be performed at an
authorized dealer .
Replacement Keys
NOTE:
Only key fobs that are programmed to the ve-
hicle electronics can be used to start and oper-
ate the vehicle. Once a key fob is programmed
to a vehicle, it cannot be programmed to any
other vehicle.
CAUTION!
• Always remove the key fobs from the ve-
hicle and lock all doors when leaving the
vehicle unattended.
CAUTION!
• For vehicles equipped with Keyless Enter -
N-Go — Ignition, always remember to
place the ignition in the OFF position.
NOTE:
Duplication of key fobs may be performed at an
authorized dealer. This procedure consists of
programming a blank key fob to the vehicle
electronics. A blank key fob is one that has
never been programmed.
When having the Sentry Key Immobilizer Sys-
tem serviced, bring all vehicle keys with you to
an authorized dealer .
General Information
The following regulatory statement applies to all
radio frequency (RF) devices equipped in this
vehicle:
This device complies with Part 15 of the FCC
Rules and with Industry Canada license-exempt
RSS standard(s). Operation is subject to the
following two conditions:
1. This device may not cause harmful interfer-
ence, and
2. This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE:
Changes or modifications not expressly ap-
proved by the party responsible for compliance
could void the user’ s authority to operate the
equipment.
VEHICLE SECURITY ALARM —
IF EQUIPPED
The vehicle security alarm monitors the vehicle
doors for unauthorized entry and the Keyless
Enter -N-Go — Ignition for unauthorized opera-
tion. While the vehicle security alarm is armed,
interior switches for door locks and liftgate re-
lease are disabled. If something triggers the
alarm, the vehicle security alarm will provide
the following audible and visible signals: the
horn will pulse, the park lamps and/or turn
signals will flash, and the vehicle security light
in the instrument cluster will flash.
GETTING TO KNOW YOUR VEHICLE
18
To Next Page
Loading...
