Dodge Durango 2018 - Erasing All the Homelink Channels; Identifying Whether You Have a Rolling Code or Non-Rolling Code Device; Programming Homelink to a Garage Door Opener

If you have any problems, or require assistance,
please call toll-free 1-800-355-3515 or , on the
Internet at HomeLink.com for information or
assistance.
Erasing All The HomeLink Channels
To erase the channels, follow this procedure:
1. Place the ignition switch into the ON/RUN
position.
2. Push and hold the two outside HomeLink
buttons (I and III) for up to 20 seconds, or
until the HomeLink indicator light flashes.
NOTE:
Erasing all channels should only be performed
when programming HomeLink for the first time.
Do not erase channels when programming addi-
tional buttons.
Identifying Whether You Have A Rolling
Code Or Non-Rolling Code Device
Before programming a device to one of your
HomeLink buttons, you must determine
whether the device has a rolling code or non-
rolling code.
Rolling Code Devices
To determine if your device has a rolling code, a
good indicator is its manufacturing date. Typi-
cally, devices manufactured after 1995 have
rolling codes. A device with a rolling code will
also have a “LEARN” or “TRAIN” button lo-
cated where the antenna is attached to the
device. The button may not be immediately
visible when looking at the device. The name
and color of the button may vary slightly by
manufacturer.
NOTE:
The “LEARN” or “TRAIN” button is not the
button you normally use to operate the device.
Non-rolling Code Devices
Most devices manufactured before 1995 will
not have a rolling code. These devices will also
not have a “LEARN” or “TRAIN” button.
Programming HomeLink To A Garage Door
Opener
To program any of the HomeLink buttons to
activate your garage door opener motor , follow
the steps below:
NOTE:
All HomeLink buttons are programmed using this
procedure. You do not need to erase all channels
when programming additional buttons.
1. Place the ignition switch into the ON/RUN
position.
2.
Place the garage door opener transmitter 1 to
3 inches (3 to 8 cm) away from the HomeLink
button you wish to program, while keeping the
HomeLink indicator light in view .
3. Push and hold the HomeLink button you
want to program while you push and hold the
garage door opener transmitter button you
are trying to replicate.
4.
Continue to hold both buttons and observe the
HomeLink indicator light. The HomeLink in-
dicator light will flash slowly and then rapidly.
Once this happens, release both buttons.
61