NOTE:
If allowed by law in the country in which the
vehicle was purchased the Daytime Running
Lights can be turned on and off using the
Uconnect System. Refer to “Uconnect Set-
tings” in “Multimedia” in the Owner’ s Manual
for further information.
High/Low Beam Switch
Push the multifunction lever toward the instru-
ment panel to switch the headlights to high
beams. Pulling the multifunction back toward
the steering wheel will turn the low beams back
on, or shut the high beams off.
Automatic High Beam — If Equipped
The Automatic High Beam Headlamp Control
system provides increased forward lighting at
night by automating high beam control through
the use of a digital camera mounted on the
inside rearview mirror . This camera detects ve-
hicle specific light and automatically switches
from high beams to low beams until the ap-
proaching vehicle is out of view .
NOTE:
• The Automatic High Beam Headlamp Control
can be turned on or off by selecting “ON”
under “Auto High Beam” within your
Uconnect settings, as well as turning the
headlight switch to the AUTO position. Refer
to “Uconnect Settings” in “Multimedia” in
the Owner’ s Manual for further information.
• Broken, muddy, or obstructed headlights and
taillights of vehicles in the field of view will
cause headlights to remain on longer (closer
to the vehicle). Also, dirt, film, and other
obstructions on the windshield or camera lens
will cause the system to function improperly .
If the windshield or Automatic High Beam
Headlamp Control mirror is replaced, the mirror
must be re-aimed to ensure proper perfor-
mance. See your local authorized dealer .
Automatic Headlights
This system automatically turns the headlights
on or off according to ambient light levels.
To turn the system on, rotate the headlight
switch counterclockwise to the AUTO position.
When the system is on, the headlight time delay
feature is also on. This means the headlights
will stay on for up to 90 seconds after you place
the ignition into the OFF position. The head-
light time delay can be programmed 0/30/60/
90 seconds.
Refer to “Uconnect Settings” in “Multimedia”
in your Owner’s Manual for further information.
To turn the automatic system off, move the
headlight switch out of the AUTO position.
NOTE:
The engine must be running before the head-
lights will come on in the automatic mode.
Headlights On Automatically With Wipers
If your vehicle is equipped with Automatic Head-
lights, it also has this customer -programmable
feature. When your headlights are in the auto-
matic mode and the engine is running, they will
automatically turn on when the wiper system is
on. This feature is programmable through the
Uconnect system. Refer to “Uconnect Settings”
in “Multimedia” in your Owner’ s Manual for fur -
ther information.
37
To Next Page
Loading...
