3. For the front tire, place the jack on the body
flange just behind the front tire. Do not raise
the vehicle until you are sure the jack is fully
engaged.
4. For a rear tire, place the jack in the slot on
the rear tie-down bracket, just forward of the
rear tire. Do not raise the vehicle until you
are sure the jack is fully engaged.
5. Raise the vehicle by turning the jack screw
clockwise. Raise the vehicle just enough to
remove the flat tire.
WARNING!
Raising the vehicle higher than necessary
can make the vehicle less stable. It could slip
off the jack and hurt someone near it. Raise
the vehicle only enough to remove the tire.
Jacking Locations
Front Jacking Location Rear Jacking Location
189
To Next Page
Loading...
