EasyManua.ls Logo

Dolmar PS-32 C - Bucking; Limbing

Dolmar PS-32 C
136 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
15
29
30
31
32
WARNING!
There is an extreme danger of kickback at this point.
Extra caution must be taken to maintain control of
the saw. To make the felling cut, follow the sectioning
-
experienced with a chain saw plunge-cutting should
not be attempted. Seek the help of a professional.
Limbing
Limbing is removing the branches from a fallen tree.
WARNING!
There is an extreme danger of kickback during the
limbing operation. Do not work with the nose of the
bar. Be extremely cautious and avoid contacting the
log or other limbs with the nose of the guide bar. Do
not stand on a log while limbing it - you may slip or
the log may roll.
Start limbing by leaving the lower limbs to support

top of the limb. Do not underbuck freely hanging
limbs. A pinch may result or the limb may fall, caus-
ing loss of control. If a pinch occurs, stop the engine
and remove the saw, by lifting the limb.
WARNING!
Be extremely cautious when cutting limbs under
tension. The limbs could spring back toward the
operator and cause loss of control of the saw or
injury to the operator.
Bucking
Bucking is cutting a log into sections.
WARNING!
1. When bucking, do not stand on the log. Make
sure the log will not roll down-hill. If on a slope,

Watch out for rolling logs.
WARNING!
2. Cut only one log at a time.
WARNING!
3. Shattered wood should be cut very carefully.

in the direction of the operator of the saw.
WARNING!

Never permit another person to hold the log. Never
hold the log with your leg or foot.

Table of Contents

Related product manuals