Instructions for periodic maintenance
To ensure long life, prevent damage and ensure the full functioning of the safety features the following maintenance must be performed
maintenance work can lead to accidents!
The user of the chain saw must not perform maintenance work which is not described in the instruction manual. All such work must
be carried out by a DOLMAR service center.
Page
General Chain saw Clean exterior, check for damage. In case of damage,
Saw chain Sharpen regulary, replace in good time 33-34
Chain brake
Guide bar Turn over to ensure even wear of bearing surfaces
Replace in good time
21, 35
Starter cable Check for damage. Replace if damaged. 39
Before each start Saw chain Inspect for damage and sharpness 33-34
Check chain tension 21, 25
Guide bar Check for damage
Chain lubrication Functional check 29
Chain brake Functional check 31
Combination switch,
Safety locking button,
Throttle lever
Functional check 30
Fuel/oil tank cap Check for tightness
Every day Clean (several times daily if necessary) 37
Guide bar Check for damage, clean oil intake bore 35
Guide bar support Clean, in particular the oil guide groove 29, 35
Idle speed Check (chain must not run) 32
Every week Fan housing 17
40
Fan compartment 40
40
Spark plug Check and replace if necessary 38
Check tightness of mounting, Check screws 17, 38
Chain catcher Check 17
Screws and nuts
Spark arrester screen Clean 40
Every 3 months Replace 40
Fuel, oil tanks Clean
Annually Chain saw
Storage Chain saw Clean exterior, check for damage. In case of damage,
Guide bar/chain Demount, clean and oil slightly
Clean the guide groove of the guide bar 35
Fuel, oil tanks Empty and clean
Carburetor Run empty
To Next Page
Loading...
