Donaldson Torit DFT 2-8 - Platforms and Ladders

Downflo II, Model DFT 2-8 through 4-128
39
1. Pre-assemble the platform according to the
instructions shipped with the platform. The
hardware and placement is called out on the
assembly drawing.
2. Lift the assembled platform into position and
secure following the assembly drawing
instructions.
3. Tighten all hardware before removing crane or
forklift.
4. Check platform hardware each time the
platform is used.
Platforms and Ladders
Stationary platforms are available for use on single
to eleven module, two filter wide units and three
module, three filter wide units.
For two filter wide units the platform is available fro
standard or steep-sided hoppers with the ladder
located left, right, or front of the platform.
On three filter wide units the platform is available
for standard hoppers only with ladder access on the
left or right side only. Complete installation and
assembly instructions are shipped with the platform.
Stationary Platform
WEJIX]FEV
PEHHIV
TPEXJSVQ[IPH
ORIIFVEGI
VEMPMRK
CAUTION!
Secure the platform assembly to the
crane or forklift with straps or clamps.