Acoustic vehicle alerting system (AVAS)
4.3-36
3- Refitting
• Insert the acoustic alerting control unit (1) to
the acoustic alerting control unit bracket.
• Pre-tighten the fixing screws (2) of the
acoustic alerting control unit and tighten it
with a Phillips screwdriver.
• Insert the acoustic alerting control unit
connector (3) and ensure it is clamped in
place.
• Refit the front bumper lower protective plate
(1).
• Clamp the 7 fixing clips (2) of the front
bumper lower protective plate in place.
• Tighten the 9 fixing bolts (3) (M6X19) of the
front bumper lower protective plate with a 10
mm socket wrench.
• Connect the battery negative cable.
• Check the acoustic alerting control unit by
the road test before starting the vehicle.
To Next Page
Loading...