DongFeng E70 - Wireless Air Leak Learning (Learning Without Tools)

Tire pressure monitoring system
4.3-15
Wireless air leak learning (learning without
tools)
1- Protection
Place protective pads at following locations:
· Front fender;
· Front bumper;
· Driver’s seat;
· Carpet (on driver's side);
· Steering wheel;
· Parking brake lever;
· Shift lever.
2- Learning steps:
CAUTION
• After the tire rotation, replace the tire
pressure monitoring sensor, and do tire
learning after the tire pressure monitoring
control unit has been replaced. When there
is no tool, wireless air leak learning can be
performed.
• With the ignition switch or start-stop button
turned to "ON" position, the tire pressure
information will be displayed on the
instrument cluster display by pressing the
instrument cluster control button.
• Press the hold the instrument cluster control
button“OK”on the steering wheel for 3 s to
enter the tire system learning mode,in this
case, the “Tire Pressure Learning Begins”
will be displayed on the interface.
• If the left front wheel (1) is deflated with air
leakage exceeding 8.25 kPa within 30 s, and
ID learning of left front wheel is completed
by the TPMD control unit, the instrument
cluster will display "Left Front Wheel
Learning Completed" and buzzer will beep
once.
• Follow the above steps to complete the
learning of the right front wheel (2), the right
rear wheel (3), and the left rear wheel (4).
The instrument cluster will display “Right
Front Wheel Learning Completed”, “Right
Rear Wheel Learning Completed” and "Left
Rear Wheel Learning Completed”.