April 2015 Vehicular Gate Operators
Swing Gate Accessories
Hinges, Torsion Rod Counter-Balance
The DKS Swing Gate Hinges are designed for heavy wrought iron gates. When using the flange style hinge, two are used at
the extreme top and bottom of the gate. When using the standard style hinge, the hinge can be welded to a gate
mounting post at almost any position and to the gate itself. For un-level swing gates, the torsion rod assembly provides a
method to counter-balance the gate to prevent gate runaway and relieves pressure on the gate operator. By adding
additional torsion rods (6 maximum), heavier gates can be accommodated.
Flange Bearing Hinge
1200-009 3000 Lb Weight Capacity
1200-010 Replacement Bearing
• Zert grease fitting
• Includes mounting bracket and hardware
• Two required per gate (top, bottom)
• Designed for use with 2” gate frame
Sealed Bearing Hinge
1200-019 2000 Lb Weight Capacity
1200-039 3000 Lb Weight Capacity
• Includes mounting bracket and hardware
• Two required per gate (top, bottom)
• Designed for use with round or square gate frames
Torsion Rod Assembly
1203-084
2600-299 Additional Torsion Rods
• Counter-balances uphill swing gates
• Includes top bracket, bottom bracket and one (1)
torsion rod
• Up to five (5) additional torsion rods can be added
1200-009 1200-010
1200-0391200-019
1203-084
4
.50
4.50
4.
25
2.00
1.50
Gate frame shown
for clarification only
3.
125
4.00
2.75
3.75
4.00
2.875
1.50
2.50
1.50
2.50
Specifications subject to change without notice. Section A1, Page 11
To Next Page
Loading...
