April 2015 Vehicular Gate Operators
Model 6524
Adjustable Limit DC Swing Gate Operator
The model 6024’s main power source is 115 or 230 Volt (switch selectable) single-phase AC power. The operational
voltage of the operator is 24 Volt DC and includes built-in battery backup (7.5 AH battery x 2) that provides continued gate
operation if the main source power is lost. This operator is designed to operate vehicular swing gates in residential and
light commercial applications.
Operator
6524-080 1/2 HP, 24V DC (1.8A / 0.9A)
• 115 or 230 VAC Input power
6524-081 1/2 HP, 24V DC (8.5A)
• 24 VDC Solar Input power only (supply your own
batteries and solar system or use DKS solar kit)
Options
1801-004 12-Volt, 18 Amp Hour Battery
• Two (2) required.
Accessories
Entrapment prevention devices (required) .....................Pg 20
Loops and loop detectors................................................Pg 21
Backup power inverters ..................................................Pg 26
6550-480 Heater Kit 115 VAC
1601-197 Heater Kit 208/230 VAC
• Heaters are active only when AC source power is
present
6500-490 Uphill Arm Pivot Assembly
• Use with 1203-084 Torsion Rod Assembly (Pg 10)
Swing gate accessories .............................................. Pg 10-11
Gate operator accessories ........................................ Pg 22-24
Max Gate
Weight (lbs.)
Max Gate
Width (ft.)
Max Cycles
AC Power
Maximum Cycles on Backup
Power**
** Actual number of cycles will vary depending on usage, accessories connected, gate weight,
operating condition of gate, temperature and charge state of the batteries.
Specifications subject to change without notice. Section A1, Page 9
To Next Page
Loading...
