DoorKing 6004 - Model 6050; 6100

Vehicular Gate Operators April, 2015
Models 6050 / 6100
Automatic Limit Swing Gate Operators
These operators can be installed on mounting posts or directly onto a concrete mounting-pad. When ordering, choose
both an operator AND an operator mounting kit. Secondary operators are used in bi-parting (dual) gate applications and
are commanded from and powered from the primary operator. Secondary operators cannot be used as a stand-alone
device.
Step 1: Choose an Operator or Operator Set
6050-080 1/2 HP, 115V (4.3A) Primary
6050-081 1/2 HP, 115V (4.3A) Secondary
• Secondary includes 30-ft interconnection cable
6100-080 1/2 HP, 115V (5.4A) Primary
6100-081 1/2 HP, 115V (5.4A) Secondary
6100-082 1/2 HP, 115V (5.4A) Primary w/C.O.
6100-083 1/2 HP, 115V (5.4A) Secondary w/C.O.
• Secondary includes 40-ft interconnection cable
• C.O. = Convenience Open (gate opens upon AC power
loss)
Step 2: Choose an Arm / Mounting Kit(s)
2600-671 Pad Mount, Arms and Hardware Kit
2600-674 Post Mount, Arms and Hardware Kit
Accessories
Entrapment prevention devices (required) ..................... Pg 20
Loops and loop detectors ............................................... Pg 21
Backup power inverters .................................................. Pg 26
1601-154 Heater Kit
• Use if temperature routinely falls below 10°F (-12°C)
6500-490 Uphill Arm Pivot Assembly
• Use with 1203-084 Torsion Rod Assembly (Pg 10)
Swing gate accessories ..............................................Pg 10-11
Gate operator accessories .........................................Pg 22-24
Model 6050 / 6100 Maximum Capacities
Model
Max Gate
Weight (Lbs)
Max Gate
Width (Ft)
Max Cycles
(Per Day)
6050
400
10
100
6100
500
14
Cont
6100 w/C.O.
400
14
Cont
Page Rev 4/1/15
Section A1, Page 6 Specifications subject to change without notice.