DoorKing 6004 - Entrapment Protection Devices Type B1 and B2

Vehicular Gate Operators April, 2015
Entrapment Prevention Devices
Type B1 and Type B2
Entrapment prevention devices are required in almost all general access automated gate applications. Photo-cells are
used as type B1 (non-contact sensors) devices. Electric edges are used as type B2 (contact sensors) devices.
Type B1 Non-Contact Sensors
8080-010 Infrared Thru-Beam
(Do not use with 9200 and 9500 series operators)
• 24 Volt AC / DC
• 65-foot maximum sensing distance
• Separate sender and receiver
• Includes hood and heated enclosure
8080-011 Photo Reflective
• 24 Volt AC / 12 - 24 Volt DC
• 30-foot maximum sensing distance
8080-030 Polarized Photo Reflective
• 24 Volt AC / 24 Volt DC
• 35-foot maximum sensing distance
8080-031 Infrared Thru-Beam
• 24 Volt AC / 24 Volt DC
• 65-foot maximum sensing distance
• Separate sender and receiver
Type B2 Contact Sensors
8080-016 6-Foot Edge (ME111)
• Includes mounting channel - ideal for barrier arms
8080-015 5-Foot Edge (ME123)
• Includes mounting channel
8080-020 5-Foot Edge (MGO20)
• Sensitive on all 3 sides – includes mounting channel
8080-021 5-Foot Edge (MGR20)
• Designed to fit on 2-inch round gate post
8080-022 5-Foot Edge (MGS20)
• Designed to fit on 2-inch square gate post
Contact Sensor Accessories
8060-061 Wireless RF Kit
• Receiver (12-24 Volt AC/DC) and transmitter housed in
NEMA 4 enclosure with low battery alarm
8080-017 Coiled Cord 16-Feet
8060-076 Plastic Receiver Box
8080-010
8080-011
8080-030 / 8080-031
8080-016 8080-015 8080-020
8080-021
8080-022
Page Rev 4/1/15
Section A1, Page 22 Specifications subject to change without notice.