April 2015 Vehicular Gate Operators
Model 9024
Adjustable Limit DC Slide Gate Operator
The model 9024’s main power source is 115 or 230 Volt (switch selectable) single-phase AC power. The operational
voltage of the operator is 24 Volt DC and includes built-in battery backup (7.5 AH battery x 2) that provides continued gate
operation if the main source power is lost. This operator is designed to operate vehicular slide gates in residential and
light commercial applications.
Operators
9024-080 1/2 HP, 24V DC (1.8A / 0.9A)
• 115 0r 230 VAC Input power.
9024-081 1/2 HP, 24V DC (8.5A)
• 24 VDC Solar Input power only (supply your own
batteries and solar system or use DKS solar kit)
Options
1801-004 12-Volt, 18 Amp Hour Battery
• Two (2) required.
Accessories
Entrapment prevention devices (required) .....................Pg 20
Loops and loop detectors................................................Pg 21
Backup power inverters ..................................................Pg 26
1601-154 Heater Kit
1601-197 Heater Kit 208/230 VAC
• Heaters are active only when AC source power is
present
9000-015 Post Mount Kit
• Includes baseplate, mounting posts and hardware.
Additional chain ..............................................................Pg 18
Slide gate accessories ............................................... Pg 16-18
Gate operator accessories ........................................ Pg 22-24
Max Gate
Weight (lbs.)
Max Gate
Width (ft.)
Max Cycles
AC Power
Maximum Cycles on Backup
Power**
** Actual number of cycles will vary depending on usage, accessories connected, gate weight,
operating condition of gate, temperature and charge state of the batteries.
Specifications subject to change without notice. Section A1, Page 17
To Next Page
Loading...
