Safety Assembly Instruction
4 ED UPS 060675 45532/17224 - 07/2023
2 Safety
NOTICE
Material damage due to electrostatic discharge
The component can be damaged by electrostatic discharge!
• Ground your body before touching the component.
• Use ESD safe tool.
WARNING
Risk of injury due to heat generation, explosion, and fire
Improper handling of batteries (e.g. overheating, destruction, recharging, use of
the battery in other products) can cause heat generation, explosion, and fire. This
poses a risk of injury.
• Only use the original dormakaba replacement battery.
• Observe warnings on the battery.
• Only use the battery as intended.
• Pay attention to the correct polarity.
2.1 Personnel qualification
Electrician
An electrician is a person who is authorized to carry out, plan and monitor
electrical work. Due to their professional training, knowledge, experience, and
knowledge of the pertinent requirements, the electrician is capable of assessing
the work assigned to them while recognizing potential hazards.
2.2 Intended use
• The ED UPS is used to keep the ED100/250 in operation in the event of mains
failure.
• The ED UPS can be mounted either during the initial mounting or retrofitted on
the ED100/250.
2.3 Improper use
The product must not be used under the following conditions:
• For double-leaf units with mechanical sequential locking control
• For operators other than those mentioned
• Any existing country-specific guidelines and regulations must be observed
before using the integrated emergency power supply on doors in preventive
fire protection.
Use of the integrated emergency power supply in combination with hold-open
systems is not permitted in Germany.
The battery pack used is a safety-related component. Only the original
dormakaba battery pack may be used, otherwise approval is invalidated.
To Next Page
Loading...
