Issued July 2024
General Information
Copyright 2024, The Heil Co.
Printed in the U.S.A.
General Information
13
Do not move the unit forward or backwards excessively fast (lurch) to dump the refuse load. Excessively fast movements with
the body raised puts a very high load on the body raise cylinders and could damage one or both cylinders and make the
body unstable unable to lower. Inspect the cylinders after you dump each load and replace if necessary.
Do not operate the unit or perform repair or maintenance procedures on the unit until you read and understand the
instructions in this manual. Failure to do so can result in damage to the unit or other property. If you do not understand a
procedure or instruction, tell the owner or the designated person immediately. Do not operate the unit if you do not
understand all procedures and instructions in this manual. The owner or designated person can contact your Heil dealer or
Heil for additional help. See the Operator’s Manual or Service Manual for contact information.
Grabbing a refuse container with too much pressure can damage the container. The container can become unusable. Use
enough pressure with the grabber to raise the container with the lift arm and not damage the container.
Always use your employer’s Lock-Out/Tag-Out procedures. If your employer does not have Lock-Out/Tag-Out procedures,
use the procedures that follow. Contact your supervisor or ESG Technical Service if you have any questions about Lock-Out/
Tag-Out procedures.
You can order Lock-Out/Tag-Out Tags through your Heil Dealer or through Heil.
To Next Page
Loading...