Troubleshooting
A70622-D1
153/192
SPS
Replacing Galvo interface Scanalone Board
Replacing the Industrial interface board
1 / 1
Special Tools
Allen Key 2mm
Prerequisite
Switch off the laser/Unplug from the mains supply
Remarks
Galvo interface board is located under industrial interface board
1
Unplug: the ribbon cable (A), both white connectors (B) and the USB connector (C) localized
2
Unscrew the four (4) CHC screw which maintai
n the board on the electronic plate, the scanalone
board is connected to the industrial board with 6 connectors. Replace the scanalone board by
disconnecting it from the industrial interface board.
3
-assemble / Re-connect all parts / connectors in the reverse order.
Scanalone Board
interface Board
To Next Page
Loading...