Dover Markem-Imaje LASER 7031 - Page 54

Printer description
A70622-D1
54/192
FS400 I/O customization
The following table gives the connection and the setting to perform according to required
working modes.
Mode
Internal
Switch
Scheme Laser settings
Stand alone :
standard
configuration
FS400 is
powered, the
system starts to
blow air.
OFF
position
Standard position
Shunt pin-1 and pin-2
M12
-
1
M12-2
N/A
Laser remote
Stop/Start
signal
An electric
interlocking
system is
necessary
between the
LASER and the
FS400 Cooler.
ON
position
The Printer controls the
FS400 by switching the
contact between pin-1
and pin-2.
Cooler
M12
-
1
I/O Board
-
Printer
J2
-
31
J2
-
30
M12-2
I/O output DS9 has to be set to “Air pump
Start/Stop”
Filter Change
System
Warning
signal
FS400 External
warning “Air
pump failure”
signal can be
sent to the
printer.
Warning
message is
displayed on the
screen.
ON/OFF
position
Air cooler
M12-3
J2
-
14 or
J2-
15 +24V DC
0V
DC
MINx
M12-5
I/O Board - Printer
I/O input MINx has to be set to “Air pump
failure”
Air pump failure