3. Attach the rear panel to a wall.
a. Select a location to attach the console to an indoor wall where it can be easily seen. Make
sure to keep sufficient access to the connection ports on the bottom of the console.
b. Hold the unit against the wall where it will be attached. There are four (4) mounting screw
holes in the unit (see the illustration above for the locations of the holes).
c. Use a pen to identify the screw hole locations on the wall.
d. Drill the holes at the screw hole location marks.
e. Tap the holes for an applicable screw size or put screw anchors in the hole.
NOTE: It is recommended to use size 6 Fischer wall anchors.
f. Attach the unit to the wall with the applicable screws.
M2050-PLUS MagLink LX Plus Installation Manual | Dover Fueling Solutions 20
To Next Page
Loading...
