Section 10 924B Probe Installation
10.1 Probe Floats
There are three types of floats used with the probes: Product, Water for Diesel, and Water for Gasoline.
IMPORTANT: The two types of water floats are NOT interchangeable. Because diesel has
more density than gasoline, the diesel floats are heavier than the gasoline floats. If an
incorrect water float is installed in a diesel tank, it will not go through the product to the water
below. As a result, the fuel tank will have unusually high water measurements. This can also
cause irregular product measurements because the water float can cause interference with
the product float.
Probe Type/Float Style Float Kits
924B 2” (5.1 cm) Floats:
Gas: 30-1509-02
Diesel: 30-1509-01
NOTICE: The product float for LPG is not approved for installations where it can be
pressurized at or more than 300PSI. Pressures higher than 300PSI will damage the device and
it will not be easy to get accurate measurements.
M2050-PLUS MagLink LX Plus Installation Manual | Dover Fueling Solutions 37
To Next Page
Loading...
